57 STEP 4 CHANGE SET POINTS TO REGISTERS FROM CONSTANTS. 55 STEP 2 MULTIPLY INPUT REGISTER BY 100. 55 STEP 1 SUBTRACT INPUT REGISTER BY 6553 – 4MA = 0. 54 Representing Numbers in the Controller. 51 ADDING HYSTERESIS TO THE PUMP CONTROL. SCADAPack TelePACE Studio 20 Contact Hours Ladder Logic Training Class May 6-7-8, 2009 Mill Valley, CA Sage Designs is hosting this 3-day course for Control Microsystems’ SCADAPack Controllers and TelePACE Studio Ladder Logic programming. 50 ANALOG INPUT TO START AND STOP THE PUMP. 49 STEP 1 STEP 2 STEP 3 STEP 4 STEP 5 CREATE TAG NAMES. 30 WRITE LADDER LOGIC PROGRAM TO THE CONTROLLER. 26 CREATE AND COMMENT LADDER LOGIC PROGRAM. 25 ADD CONFIGURATION AND DIAGNOSTIC I/O MODULES. 25 CONFIGURE 5000 SERIES I/O MODULES USED IN THE APPLICATION. 24 CONFIGURE CONTROLLER REGISTER ASSIGNMENT.
#Telepace studio activation serial
24 CONFIGURE CONTROLLER SERIAL PORT SETTINGS. 23 CONFIGURE CONTROLLER FOR SERVICE MODE.
#Telepace studio activation install
23 INSTALL SERIAL CONNECTION BETWEEN PC AND CONTROLLER. All other product names are copyright and registered trademarks or trade names of their respective owners.ĬONTROL MICROSYSTEMS SCADA products. Trademarks TeleSAFE, TelePACE, TeleBUS, SmartWIRE, SCADAPack, SCADAWave, and SCADARange are registered trademarks of Control Microsystems Inc.
TelePACE Studio Ladder Editor Training Manual ©1999-2009 Control Microsystems Inc.
0 kommentar(er)
